Farmall & IHC Tractors Discussion Board |
Re: A front crank seal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by scotty on October 16, 2006 at 04:54:20 from (199.231.49.128):
In Reply to: A front crank seal posted by wayno on October 15, 2006 at 18:41:04:
Mornin Wayno, All good advice from the others but I did something a little different. Instead of a .002 pressfit on that front pulley. When I got it off, I used a flap wheel in the lathe to open up the bore to make the reinstall just a light tap fit and I used two setscrews on top of the woodruff key to keep the pulley from moving. The nice thing about doing this is you can slightly reposition the pulley so the seal is not riding on the worn diameter and will not leak. Some people use the speedy sleeve but this way you dont have to . Just a suggestion, it worked fine for me, but I have the tools at work to do this since I am a toolmaker by trade. scotty
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|