Farmall & IHC Tractors Discussion Board |
More help with my Voltge Regulator Please
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Williams on October 09, 2006 at 21:37:20 from (24.113.128.168):
I have spent several hours pouring over the help you have provided and the manual, but I cannot make it work. The picture shows what I know. The first pole has an open contact and has 0 ohms. The next one has a closed contact, is labeled A and has 7 ohms. The final one has a closed contact and has 1 ohm. I have hooked the F wire to the generator and the A terminal to the A terminal on the generator. The final pole I have hooked to the voltage gauge and then to the battery terminal on the ignition. The ignition then goes to the starter solenoid and the other pole on the starter goes to the correct connector on the ignition coil. When I turn on the ignition it turns the motor over but there is no spark. I have not found where the battery lead goes. When I put it on the B/L terminal of the voltage regulator it shorts out. Same when I put it on the battery pole of the ignition. (It is the same as putting it on the B/L terminal of the VR). It doesn"t look as bad as the pic indicates, and there aren"t any obvious mechanical defects, shorts, etc. Please help! Thanks in advance!!
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|