Farmall & IHC Tractors Discussion Board |
Re: To all owners of A, SA, 100, 130 and 140 tract
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on September 28, 2006 at 11:45:38 from (4.227.107.253):
In Reply to: To all owners of A, SA, 100, 130 and 140 tractors posted by Hugh MacKay on September 28, 2006 at 04:03:18:
We have two 140's and a Super A that I restoring. On the 140's one has a fast hitch and one has the draw bar, we never change them. On the Super A I am working on I want cultivators on it but I also have the U draw bar and the swinging draw bar arm. Hugh, I just dont see a way to have both but I have an idea. The anchor bar for the swinging arm is pretty stout built so why not use it as the draw bar. Mount it on the top holes on the final drive above where you normally would for the U draw bar. It would be up higher which might or might not be good. I know I would use the lug nut type nuts to secure them and not just bolts. Another idea would be to have a bar made that would fit betwenn the two arms of the cultivators where you could take it on and off. Cultivator brackets dont appear as heavy built tho as the draw bar brackets.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|