Farmall & IHC Tractors Discussion Board |
Re: how to install pilot shaft and clutch release
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by terryjd98 on September 22, 2006 at 17:45:40 from (69.159.79.85):
In Reply to: how to install pilot shaft and clutch release bear posted by Bill Zuke on September 22, 2006 at 15:56:12:
The clutch that I just put in the M that the tractor supply store ordered in over night came with 2 wrong sized bearings. They had to match up 2 new bearings with the old ones in the tractor. Nobody was sure why, they said all the M's took the same size bearings but guess they don't or maybe a W6 had same clutch different bearings don't know?? Could this be the problem just wrong sized bearing? With right bearings clutch should go together fairly streight forward. I have a different problem myself with the new clutch install that I posted. Good luck. Terry
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|