Farmall & IHC Tractors Discussion Board |
Re: need some info on an M head
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on September 20, 2006 at 14:00:30 from (66.228.96.230):
In Reply to: Re: need some info on an M head posted by MJF on September 20, 2006 at 12:45:49:
I have custom setups with pistons and rod combos that can put a 281 in the 70 hp range with an old 8060 head. I like the M throttle body better, larger idle circuit, and add a 6 cyl carb bowl, and you can idle a stock to pretty modified engine,,,, If your 281 makes 150 psi, thats in the 55-60 hp range. Save your money on the custom cam,, the 450 cam is great! Find one of those, you wont be disaponted. The heads are the same,, just one is newer than the other,, less prone for cracks??? maybe,,, M block wont take the 450 sleeve flange size,, have the sleeve flanges cut back to the M specs,,, bore the M block to 4.25 and drop in the 450 sleeves. make sure the block is good, cause old M blocks are thin at the bottom,, even at 4.25. Chad
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|