Farmall & IHC Tractors Discussion Board |
Re: UHM IHC power unit
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Duner Wi on September 19, 2006 at 20:28:04 from (63.26.83.79):
In Reply to: Re: UHM IHC power unit posted by steelfronts on September 19, 2006 at 19:57:31:
It has 2 pieces above the head . One is cast about 3 inches thick and the top valve cover is stamped tin. There is no flat tube for the plug wires but may have had one once. I have not taken the stamped tin cover off yet but expect the cast piece directly below the tin is held by the head bolts. It does have I think 10 head bolts exposed on the right side. The stamped #s on the pad on the left side are UHM. Could the HM portion be it was speced a certain way by snogo? I did find on a google another owner of a snogo saying his engine had a tag saying UHL-1 as well as the UHM stamped in the block. I also found a snogo with a UD engine but don't know what that is . Didn't the W40 have a FAA ,FBB or FBC which may have predated the Red Diamond 361? Any help would be appreciated.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|