Farmall & IHC Tractors Discussion Board |
Re: super m----450
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by D Slater on September 19, 2006 at 17:41:42 from (64.12.116.65):
In Reply to: Re: super m----450 posted by Wardner on September 19, 2006 at 16:59:32:
The gear that drives belt pulley gear box is located on transmission input shaft just in front of gear on input shaft that drives constant mesh gear. On some shafts the belt drive gear is just elemanated since thats all it drives and may not be needed. More common to find it elemanated on 300 460 etc. because the utilitys didn't use. IH sold input shafts for 450 560 etc. without pulley drive gear on them also. Have worked on T/A with no pulley drive gear and IH part # on shaft. He probably has gear,just pointing out possibilities. Also even though all boxes will bolt on there's slight differances in housing shapes and operating levers.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|