Farmall & IHC Tractors Discussion Board |
Re: How to flush hydraulics and WTH is this?!?!?!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by janicholson on September 10, 2006 at 19:57:42 from (66.173.50.148):
In Reply to: How to flush hydraulics and WTH is this?!?!?! posted by JayWalt on September 10, 2006 at 17:55:11:
Though I'm not sure it is all applicable, hear is a repeat of the advice I gave in a prior post: When the tractor is cold, I would remove old screen and drain as much fluid as possible from the res. If you can, use a suction gun (looks like a grease gun that sucks) to get all of the fluid you can out of the system. I would then replace the screen and fill the res with new fluid. I would use an open hose on a remote cylinder connection into a bucket. Before starting the tractor, move the control lever to the position that will apply pressure to that hose. Then, with the lever moved, momentarily start the tractor 10 to 15 seconds. This should flush out that line into the bucket. If milky fluid is still comming out fill the res with new fluid again, and repeat until new fluid comes out. Then connectr to the other remote line and do the same thing, till clean fluid comes out. Refilling of course to prevent air from entering the pump. Next (if i was thorough) I would remove one of the FH cylinder hoses and blead that till new fluid came out. then the other side of the FH cylinder. This process prevents old fluid from being sucked back into the res. and also prevents the mixing (as much as possible) old and new fluid. Working the tractor for several hours will eventually drive off the remaining moisture from the system. Good luck, JimN
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|