Farmall & IHC Tractors Discussion Board |
Re: McCormick 45 square baler
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron-MO on September 08, 2006 at 06:52:16 from (208.210.74.251):
In Reply to: McCormick 45 square baler posted by Ben Ford on September 07, 2006 at 21:09:18:
Like teddy52food said - it has been probably 30 years since I baled with a 45, but if memory serves me correctly it is not difficult to find the rought to the needles then jus tie it off to one of the guards below or a point on the frame and trip the knotters. Good luck with the old #45. My experience is that they are very tempermental. I spent many hours 'riding' the twine box on that one with dad driving the tractor and me tying the loose knots. But we baled thousands of bales that way over the course of about 10 years. We used to think that we simply did not know how to set it up properly, but since visiting this board I have learned that that was the 'nature of the beast'. I hope I have not discouraged you on it and you have good luck with it.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|