Farmall & IHC Tractors Discussion Board |
Re: Fire Crater pistons in Farmall H, like more i
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by HoosierHawk on August 29, 2006 at 18:03:22 from (205.188.116.133):
In Reply to: Re: Fire Crater pistons in Farmall H, like more i posted by Jonfarmer on August 29, 2006 at 17:23:19:
I know what you mean. I had a broken #1 piston, tried replacing just it and the rod, and 4 new rod bearings, put it all back together and still no compression on #1, figure the sleeve's oval or something. Took everyone's advice here and now have the head, crank, block, cam all at the shop getting "Newized". Gonna be a month or two before I can afford to get an overhaul kit, but hope to have it together by Christmas, and tractor all done by spring. A lot more to it than I planned on, but lovin it. The Elders here will tell you to get all the manuals and search previous posts here for just about any information you need. Took me 20 seconds to get those links for you in first reply. I've learned a lot from reading them, more than you hope to learn when you first start searching a topic, they take you into other areas you might not think of. Pics here of my build so far, if you'd care to see. B
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|