Farmall & IHC Tractors Discussion Board |
Re: 315 and m
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bm3501466 on August 29, 2006 at 08:52:35 from (24.27.181.2):
In Reply to: Re: 315 and m posted by Nat 2 on August 29, 2006 at 07:38:08:
A 315 has a six cylinder engine. Just about all six cylinder IH engines share the same bolt pattern as the M. You just have to extend the frame rails to make it fit length wise. A naturally aspirated 414 does not have enough horsepower to tear up a rear end on a M. I have seen people fix up Ms with over 150 horse and it does not hurt the rear end.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|