|
Farmall & IHC Tractors Discussion Board |
Re: correct tire size
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on August 23, 2006 at 11:50:43 from (75.24.29.127):
In Reply to: correct tire size posted by mta man on August 23, 2006 at 11:27:19:
Back when New it was a 12x38 and that was replaced with the 13.6x38 , now the 15.5 is the same hight as the 13.6 but the 15.5 should be on 14 inch wide rims to keep it layen flat . what looks real nice on a S/MTA is the 14.9 x38 but here again it takes a 14 inch rim . You can split and weld in a band to widen your rims out if it has the 12 inch rim on it now and if done wright you can not realy tell . I widend the rims on mine and made mine 15 1/2 inchs wide and like a dumb Arrs i put 16.9x38 on it just so i could go play tractor pullen , should have listened to my inner self and went with the 14.9's as they are a bit taller then the 15.5 and darn near as wide as the 15.5 and they do look good on a MTA . THe only nice thing about the 16.9's is THE ROAD SPEED With the govener set at 2100 she will get down the road.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
