Farmall & IHC Tractors Discussion Board |
Re: adding an extra reservoir to Lift-All on Farma
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Loren P on August 17, 2006 at 13:16:39 from (64.65.174.118):
In Reply to: Re: adding an extra reservoir to Lift-All on Farma posted by Michael Sheik on August 17, 2006 at 12:47:56:
I suppose that not having oil in the cylinder reservoir would allow the ram to pull out on it's own after the load shifts past the pivot point, assuming the reservoir is the back side of the ram. I've seen this happen with the hoist on our 1 1/2 ton Chev, which uses the cylinder reservoir. When dumping a load of rock, the bed will flip up all the way after enough rock moves to the back. I'll be hauling mostly black dirt for landscaping around the house, so it shouldn't be much of a problem, since the dirt doesn't roll off very fast.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|