Farmall & IHC Tractors Discussion Board |
Got that *$%^$ A front end apart but...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by kopeck on August 14, 2006 at 08:46:45 from (169.244.143.115):
A few weeks ago I posted about trying to get my Farmall A's front end apart (that is to make it wider). Well two of my buddies showed up after work with the torch and we got that blasted thing a part. It was stuck pretty good but it did give it. We wire brushed it all and put it back together with some sort of synthetic lube (grease) that he brought from work that suppose to even ward off salt. Anyway it nice to have the thing all fixed up but in the process of getting the thing separated we ended up putting a little dent in the spindle. Now we tried our best not to dent it using wooded blocks and a dead blow hammer but it happened. My question is: is there anyway to get that dent out? It's not hurting anything but my eye, and I have to get close to even see that. Thanks, K
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|