Farmall & IHC Tractors Discussion Board |
Re: Re plugs fouling
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on August 12, 2006 at 20:41:24 from (75.24.6.64):
In Reply to: Re: Re plugs fouling posted by Wes in Ohio on August 12, 2006 at 19:59:10:
Alwright Try this i\, i know that i'll get some flak here but BTDT Get the stock 6 volt coil and the ballast resistor From Case I H for the coil and install that make sure that ya put the termianls to the dist. the correct way for the polarity of the tractor . I have found that this system works better on all the ones that i have changed over from 6 to 12 . make sure that your plugs are gapped at the .025 . Whenit is idealing do you have any smoke comming out the exhaust ?? at ideal ?? . Now as for the main jet setting if everything else is wright i have never ever seen and over fuel problem on any stock tractor that i have worked on now if someone has drilled the main jet or the float is way to high then it can over fuel . Now as for the comperssion readings she is a tad low but hey she ain't new . My S H is in that range and i have no problem with fouling plugs on her . If ou were close to me i would give ya hand on it .
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|