Farmall & IHC Tractors Discussion Board |
H axle seal replacement
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rock2000 on August 11, 2006 at 21:29:40 from (65.75.33.101):
I hope this isn't a stupid question, since the messages I could find on this topic all to seem indicate that this is so obvious that it doesn't need details, but... I've got the axles (and other parts) off of our H and I want to replace the outter oil seals on the axles. I took the cap off without much trouble, but the seal looks like it's pressed in but can't be pressed out? The hole that seal is pressed in doesn't go all the way through the cap, so it seems like you'd have to pull the seal out or something, which for a press fit just seems wrong. Am I missing something obvious? How do I get the old seal out of the cap so I can press in the new ones? Thanks
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|