Farmall & IHC Tractors Discussion Board |
H Belt pulley seal replacement
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rock2000 on August 06, 2006 at 19:34:57 from (65.75.33.143):
I have our 1950 H apart for some transmission work, and I'm going to replace the seal and probably a bearing in the belt unit while everything is apart. I've tried to pull the belt shaft out before and replace the seal (figured it would be easy), but the shaft won't come out. I thought I would see more now that it's off, but I still have no hint how to get to the seal. My service manual doesn't go into details about disassembly, so if someone can't solve this mystery for me, I guess it's time to start unbolting stuff and see what happens, which makes me a little nervous. Doesn't seem like it should be this difficult though. What am I missing? Thanks
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|