Farmall & IHC Tractors Discussion Board |
Re: Farmall Regular Questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dej(JED) on July 26, 2006 at 09:24:56 from (66.212.151.134):
In Reply to: Farmall Regular Questions posted by Hal Davis on July 26, 2006 at 08:50:43:
The plate with the serial number would be located on the tool box , under the gasoline tank , near the rear of the engine block. If it isn't there then look on the top of the frame rails near the front of the tractor. They were stamped in the metal there. I would guess that the levers were for what you have described, the shutters and the mag advance. Since these tractors had no oil pump, I am confused about your plumbed in filter. Those engines were manually lubricated on the top end and the bottom was simply a dip system lubrication. I have a good manifold and a carb if you need one.
Replies:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|