Farmall & IHC Tractors Discussion Board |
Re: charging
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on July 18, 2006 at 19:31:43 from (66.244.90.5):
In Reply to: charging posted by adam jones on July 18, 2006 at 15:43:22:
Adam, some of those voltmeters dont have very much/good resolution, but I would still expect it to rise from the battery voltage setting not running of 12.6 volts to near 14 when running wide open and the lights should glow noticeably brighter form setting to wide open running IFFFFFFFFF its charging. Is there still an ammeter that works you can wire in??? If so the alternators main output (assuming thats what the kit uses???) wires to the ammeters Load side, same place the BAT terminal on a VR or Cutout relay used to wire, and its other supply side wires to the battery/starter maybe at the starter switch or solenoid where the big battery cable attaches. Is it a one wire or a 3 wire alternator?? If a 3 wire it needs excitaion voltage supplied on its lil side No. 1 terminal and if a one wire it may still need flashed before it kicks in. The only way to tell if its charging is if the battery voltage rises from its normal 12.6 volts and/or the ammeter shows a charge and/or the lights glow brighter at Rpm. John T
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|