Farmall & IHC Tractors Discussion Board |
Re: Farmall A front end stuck
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brownie 45 on July 15, 2006 at 14:37:11 from (207.177.82.186):
In Reply to: Farmall A front end stuck posted by Kopeck on July 15, 2006 at 06:19:37:
If you have two other tractors & a 2- way hydraulic cylinder, use log chains on the axle ends & hook one end to one tractor drawbar, & the other to one end of the cylinder. Extend the cylinder fully & hook the other end of the cylinder to tractor # 2 drawbar. Retract the cylinder slowly in small steps, watching for any problems with chains or other attaching parts getting out of shape. A little light tapping with a 10 lb. sledge will help. Use common sense when applying pressure. A 4" cylnder or larger will work best. We have used this method to pull rusted PTO shafts & other"sleeved" shafts apart.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|