Farmall & IHC Tractors Discussion Board |
966 Injection Pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chadd on July 06, 2006 at 17:05:46 from (65.54.154.47):
Hi guys, I found out from you guys that the serial number of our 966 is number 28111, which puts it in the late 1974 age range. I'd heard that the max rpm for a later 966 is 2800 no-load rpm. Ours will only go up to 2500 no-load rpm, and the pump says on the plate that its max high-idle rpm is 2600. Which number is right? Ever since it came back from the dealer after they "fixed" a leaky injector and replaced the idle screw on the back of the pump, it has lost a lot of power (it used to be 110 horsepower). Now since I have replaced the injector again (it started leaking again), it seems that it will not run right at all rpm levels. It sounds good at mid-to-high range, but seems to have a cylinder running out of time at low rpm (1000 or less), as it seems to gallop a little, and will also smoke blue, but clears up as rpm increases. (it hasn't lost any oil in 2 months of use, so I assume it isn't oil burning) Any Ideas? Thanks in advance.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|