Farmall & IHC Tractors Discussion Board |
Re: 300 Transmission Noise
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by biggerred on July 01, 2006 at 10:03:14 from (12.8.252.204):
In Reply to: 300 Transmission Noise posted by Stu Red on July 01, 2006 at 05:56:02:
I just got my 300U broke in 3rds and found all the drive shaft bearings worn out,(between the clutch and trans) to the point you could press out the inner races. That old gal was real loud around the shifter area. I got all new bearings from Case/IH, and the price was not that bad either (SHOCK). I am however, still looking for a trans drive shaft for a non t/a tractor. Mine is VERY pitted where the transmission pilot bearing rides.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|