Farmall & IHC Tractors Discussion Board |
Re: Hydro 100
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Sheepdog in NE on June 30, 2006 at 19:33:04 from (67.0.3.219):
In Reply to: Hydro 100 posted by Bretg on June 30, 2006 at 07:47:42:
Don't know where to get info, someone will know. Can tell you that hi range is only a gear that is speeding up the pinion shaft. If it works in low should be OK in hi. Now in saying that hi does take more power but still. If you are going down the road it should get to 18 mph without a load on the draw bar. If you can kill the tractor by holding the brakes, engine at 1800 or more rpm, pushing the forward reverse forward then it's OK. Keep the lever in the blue area tho. In hi or low range. If the engine keeps it's rpm then you have trouble. Piston heads are wore, plates can be scratched, center housing cracked. How much did you plan on doing with this tractor? It will make a great yard trator, baling, etc. Light work only. I would'nt pull a plow for very long. Ask more again. Good luck.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|