Re: timing a 436 motor

Posted by Sheepdog in NE on June 25, 2006 at 19:55:44 from (67.0.14.107):

In Reply to: timing a 436 motor posted by Larry B. - 1466 on June 25, 2006 at 17:49:59:

There is a cover that the tach cable goes to opposite the fuel pump. Take it off and you'll see a gear with 3 bolts holding it on. Loosen the bolts. Also take out a plug using a 1/2" drive ext, that is located a about 7 o'clock under the pump mounting flange. Make sure the flywheel is on your #18 setting. Look in the plug hole and there will be two marks. They need to be lined up with each other. Take a socket (maybe a 3/4 or 15/16) place it inside the three bolts you loosed and you will move one of the marks. If it is not moving then you are at the end of the slots with the 3 bolts and you need to remove the 3 bolts pull the gear off and move it one tooth. Then you'll be able to line up the marks. Tighten the three bolts. Not sure on the torque setting thou.

Replies:

• Re: timing a 436 motor Larry B. - 1466 10:35:06 06/26/06 (2)
  • Re: timing a 436 motor Sheepdog in NE 14:21:10 06/26/06 (1)
    • Re: timing a 436 motor Larry B. - 1466 15:38:19 06/26/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]