Farmall & IHC Tractors Discussion Board |
Re: MW 9-speed and hand clutch
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy as in Randy-IA on June 20, 2006 at 16:21:26 from (207.177.83.188):
In Reply to: Re: MW 9-speed and hand clutch posted by randy hall on June 18, 2006 at 19:44:04:
Hi Randy , Sorry I didn't respond last night but I have to sleep some time and it was getting late . Thanks for price range . I have a m&w but was looking for a set of parts gears . When I looked in my fill hole of the trany I saw a lot of rust pits on the gears . I think this tractor must have been saved from a grove somewhere . When I pulled the oil pan I found leaves and twigs in the crankcase . But it all works and it runs pretty good so I'm not to worried . The trany growls but I think that is a bad bearing in the input shaft or counter shaft . It growls in neutral sitting still also . If it is a bad bearing then the gears may be worn lopsided so I want a better gearset handy before I open it up . There's a 9-speed I found on ebay but it's up to $510 and I don't want to pay that much but it comes with the complete trany . Take care ...Randy
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|