Farmall & IHC Tractors Discussion Board |
Factory 400 LP with Ensign regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmallkid1958 on June 19, 2006 at 05:30:12 from (216.21.190.37):
I have a factory 400 LP and I am having a problem with the Ensign regulator on it. The regulator has had a humming sound coming from it for some time and now it seems to be starving for fuel. Is there any adjustments on this regulator or does it need to be rebuilt? I have seen posts before about someone in Oklahoma or Kansas who makes kits for them. Does anyone know who this is or have a phone # for them. Any other advice, tips, or information on this subject would be greatly appreciated. Does anyone know where there might be a rebuild kit or complete regulator laying around that I might be able to purchase? This tractor is way to nice not to keep it original, And I would like to keep it that way if possible. Thanks
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|