Farmall & IHC Tractors Discussion Board |
Re: Finish mower on a 200
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BobG in VA on June 18, 2006 at 16:33:37 from (64.12.116.65):
In Reply to: Finish mower on a 200 posted by Heywood on June 18, 2006 at 11:10:01:
I think you'll be fine with a 72" finish mower if your 200 is in good tune. I "assume" you have a 3 pt conversion on your FashHitch.... If your grass is a tad high to start with, put the wheels on the finish mower as high as they will go and go over it. Once you have done this lower your wheels and do it again until you get the height you are looking fore. My bud has a good running SC that he runs a 84" Kioti finish mower at half throttle in 2nd gear and it cuts great (Mind you he's been cutting this grass for years so its well groomed. If you can't get the finish mower wheels high enough to ruff cut the grass, raise the mower some and go over it that way---very slowly as the front end can get very light with a big mower on the back. BobG in VA
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|