Farmall & IHC Tractors Discussion Board |
Re: Oil Pressure...shims in the pump etc. H Farmal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Easy on June 13, 2006 at 01:58:54 from (198.208.251.24):
In Reply to: Oil Pressure...shims in the pump etc. H Farmall posted by Tom Windsor on June 12, 2006 at 19:29:11:
I rebuilt mine, the gears had worn into the cover quite badly. I took the cover off, put it on a surface grinder to grind it flat. Headspace has a big effect of pressure. The gears, due to pressure, will always wear into the cover. Then I put it back, I took out all the shims, because I measured the gear length and it was short. I ground down the body untill I had .001 clearance between the gears and the cover. I Have had excellent pressure. It has been 10 years, but I don't remember the pressure relief valve?
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|