Farmall & IHC Tractors Discussion Board |
Re: Oil Pressure...shims in the pump etc. H Farmal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on June 12, 2006 at 20:07:53 from (204.249.178.138):
In Reply to: Oil Pressure...shims in the pump etc. H Farmall posted by Tom Windsor on June 12, 2006 at 19:29:11:
Quoting from the H service manual -- I have not done this--: "Gaskets between the body and cover are .006 inches thick; use these as shims to obtain .003-.005-inch end play of the drive shaft when assembled. Idler shaft should be concentric with body bore and square with the bottom of the gear chamber within .001 inch." In other words you use gaskets as necessary to get the proper clearance. If the pump was working ok to begin with, put the same number of new gaskets in as you took out--I'm not the expert on this. Further info is in the service manual, too much for my slow typing. The relief valve itself should still be available from Case-IH.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|