Farmall & IHC Tractors Discussion Board |
Re: super a alternator bracket
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on June 01, 2006 at 18:12:24 from (209.226.106.83):
In Reply to: super a alternator bracket posted by Bobby in SC on June 01, 2006 at 17:33:24:
Bobby: There is no such kit, much to easy to fabricate. It's quite easy to make if you use the generator mount, just weld 3/16 x 2-1/2 x 6 inch plate on top of the old gen mount. Weld on two tabs with holes for alternator mounting pin. Change the alternator pulley to one of the old V8 GM double pulley. By using the outer pulley, this allows you to position alternator back far enough to clear the front of engine casting, and still tuck alternator in close to block. My alternator sits within 1/2" of the engine block. Another thing I always do is space those tabs for alternator mounting about 1/4" wider than alternator mount. By using washers you can get the belt true. If you want a photo send me an e mail, I think I can find you a decent close up. It may be 130 or SA but they are both the same.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|