Farmall & IHC Tractors Discussion Board |
Re: Farmall A (4 position) switch getting too hot
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MACE on May 23, 2006 at 12:39:09 from (66.83.16.196):
In Reply to: Re: Farmall A (4 position) switch getting too hot posted by Janicholson on May 22, 2006 at 18:32:30:
Jim N, I have double checked that the resistors or anything else hot or electrical does not touch. All I do is touch the amp cover to the case (I do not put it on all of the way) and I get a 2 amp draw) When I disconnect the battery wire from the back of the switch (the one that goes to the generator) then I know longer have a 2-amp draw. Upon taking the switch completely apart the other day, I found that it has some sort of mechanical cutout internally when it is turned completly counter clockwise. It is in the round part of the switch. Does anyone know what this part of the switch is used for. BTI. I installed a new regulator, generator, and wiring harness about a year ago. Thanks, MACE
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|