Farmall & IHC Tractors Discussion Board |
Re: Hardening Metal I will tell you why
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Magman on May 22, 2006 at 15:52:58 from (152.163.100.65):
In Reply to: Hardening Metal posted by MAGMAN on May 22, 2006 at 13:51:22:
The distributor clips on magnetos are like spring steel and are about 1/32" thick and about 3/8" wide and are so hard that they will break before they bend to much. Well I have about 5 mags here that are missing the clips so I tryed to order with no luck and desided to try and build my own. Out of sheet metal. The heating and dipping in oil helped a little but it still bends by its self under the pressure of holding the cap in place. JON
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|