Farmall & IHC Tractors Discussion Board |
140 Lift pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Avery on May 15, 2006 at 05:43:59 from (206.107.117.6):
During the production run of the Super A, 100, 130, and 140 Internationals. There were several lift pumps which were used to my knowledge. The Pesco, Thompson, Cessna and Wooster. With Wooster being the last one used I think. Of these does anyone know which was considered the best and had the highest volume of GPM and hence higher lift capacity. Did they upgrade the pumps through the production run because some were improvements. Would the later model 140's have received a pump which had a higher gpm rate than say a 100 or super A. However a pump off of one of these would fit a later model 140 but if had a lower gpm rate with volume pumped being lower the lift might not be quite as strong. Am I correct in my thinking ... Thanks
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|