Farmall & IHC Tractors Discussion Board |
Re: Ok..who said plowing is easy?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tedd on April 22, 2006 at 15:29:30 from (24.51.22.226):
In Reply to: Ok..who said plowing is easy? posted by Paul Shuler on April 22, 2006 at 13:44:37:
Paul, I think that when you "still" have that snow plow on you are losing some of your rear drawbar control capabilities (sp) with that linkage. We have not plowed with our Super C in a long time but I am going to take a look at it. Your tractor should not be struggling. Also there is a verticle shaft in the back of your tractor that a pin can be installed in if the pin is in you can block the draw bar and lift the back of the tractor when it is out it will allow the draw bar to float or in your case the plow to float or stay at at cosistent depth take a look back there. Also the draw bar should float left and right there are pins with two alowable positions on the left and right that will allow this. I am far from an expert but I have spent some time with this rig.Please excuse the spelling.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|