Farmall & IHC Tractors Discussion Board |
Re: B valve adjustment, what happened?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on April 13, 2006 at 18:47:03 from (205.188.116.133):
In Reply to: B valve adjustment, what happened? posted by TKN on April 13, 2006 at 11:48:20:
You should mark the timing mark on the flywheel with some chalk. Then remove No1 sparkplug and hold your thumb over the hole while someone slowly turns the engine over until you feel pressure against your thumb. Keep turning the engine slowly until your timing mark is aligned with the indicator. The engine should now be at TDC on the compression stroke. Your rotor should now point to the No1 plug tower and both valves on No1 cylinder should be closed. Valves 3 & 5 should be closed too. If they are closed you now can adjust these valves. Then turn the engine one full revolution and adjust 4, 6,7 & 8. They should be closed too. Rotor should be at No4. Hal PS: Set them at .017"
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|