Farmall & IHC Tractors Discussion Board |
B valve adjustment, what happened?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TKN on April 13, 2006 at 11:48:20 from (192.112.2.60):
I recently completed a B- Farmall re-build. I started it up a couple of weeks ago. Everything seemed good with the exception of the throttle didn't seem to be working right which I assumed was an adjustment issue. The last thing I had left to do was to adjust the valve levers. I got the instructions off this Board a while back and followed those instructions. It basically said to get the #1 cylinder on TDC and set #1,2,3 and 5, then get the #4 cylinder on TDC and set 4,6,7 and 8. All at .014. I did that and tried to start and it started very briefly and struggled to run then died quickly never to start again. Is that the correct gap and procedure? The page I used appeared to be from an IH manual.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|