Farmall & IHC Tractors Discussion Board |
D-300 vs D-400 engines
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by The Farmall on April 12, 2006 at 14:50:33 from (24.153.215.10):
I am curious if a D300 series rear engine cover and a D400 series are the same. I have a 400 block torn down and I put a 300 oil pan gasket up to it and they were the same width just the 300 was about 3 inches shorter. Will the rear engine plates enterchange? Also the international 666 tractor. Are there any other tractors that used the same bell housings and rear ends that the 666 used. Was the 666 the same as the 560? Is there any way to put a D358 in a 560?
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|