Farmall & IHC Tractors Discussion Board |
Re: changing brake bands on farmall H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by riverbend on April 09, 2006 at 07:02:34 from (208.160.33.154):
In Reply to: Re: changing brake bands on farmall H posted by lekander883 on April 09, 2006 at 05:59:12:
There is a band on either side. You might not notice anything leaking until you get the band off. If the seal is bad, the band will be soaked with grease. I have found that aftermarket bands are thinner than IH, and I have had trouble with them breaking. Others here do not seem to have that problem. I bought an IH replacement band a couple weeks ago. It was $75 at the local dealer, but when I get to the end of the field, I would rather turn than go through the fence. Once you install the new bands, you will have to adjust them. The operator's manual gives the procedure. When I adjusted mine, the covers would get warm when I was driving the tractor and I had to loosen the adjusters another 1/4 turn. Greg
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|