Farmall & IHC Tractors Discussion Board |
Re: M carb problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chadd on April 07, 2006 at 05:26:48 from (155.92.31.140):
In Reply to: M carb problem posted by Hank L on April 06, 2006 at 22:25:21:
I am not sure about the earlier combines, but our 105 made by IH in the 60's-70's with the C-153 didn't have a provision for throttle control. It only had a setting for idle and a setting for wide open throttle, the idea being that users wouldn't complain that the shakers weren't doing their job or were clogging up, which was caused by running the machine at too low of rpm. I am not sure if it was accomplished by the operator platform linkage at the front or if the carb and governor were differently designed. Maybe someone else can give you more info. I don't think there was a combine with an M motor. The only longshot I can think of was the 140 combine, which used a Farmall 300 motor. Good luck.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|