Farmall & IHC Tractors Discussion Board |
SH head question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jaybird2 on March 29, 2006 at 18:20:07 from (66.41.212.16):
Kind of embarrassed to ask this question because I think I know the answer but just want to check with you guys first. I just had a super H head repaired and reinstalled it today. I got done torqueing it down and realized that the throttle linkage bracket on the carb side was hanging there waiting to be installed. I forgot to pay attention to where I removed it from and have a feeling it should have been installed on the two studs near number 3-4 cylinder. Do I have to completely undo the head so that it gets retorqued in sequence or can I just back those two nuts off, install it and retorqe it? Or am I not even installing it in the right place. Thanks for your help. Jay
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|