Farmall & IHC Tractors Discussion Board |
Re: Lift pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Magman on March 28, 2006 at 18:26:08 from (152.163.100.65):
In Reply to: Lift pump posted by RSK on March 28, 2006 at 14:39:23:
I dont know what you have when you say the rubber hydraulic fittings . The pump is a gear driven pump with round steel balls that hold the pressure. How about the fitting that runs the pump from the tranny are both pins in it and hooked up right? The clutch deal is becuase it runs off the tranny and its always running when the clutch is out and when you push the clutch pedal down it disingages the pump. You may have a broken tooth on one of the gears inside I supose or there is a rubber mount in the clutch housing in the center of the drive shaft maybe thats ripped or bad also. Just a few things I can think of to check JON
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|