Farmall & IHC Tractors Discussion Board |
400 rear main seal ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by super99 on March 15, 2006 at 15:38:02 from (207.144.222.181):
I want to replace rear main seal in 400 gas. Have seal and gaskets. It is 2 pieces. Do you have to take off plate that goes between engine and bell housing? Have bolts put, not enough room to get top 1/2 out and bottom 1/2 set on a ledge. Is that part of the oil pan? Could probably pry top out but bottom isn't going to. Surely someone has done this, is there something simple I'm missing or do you have to take more off to get to it? Also, The two locking straps for flywheel bolts need replaced and CIH dealer says they are not available anymore. Someplace to get them or make your own?? Thanks in advance, Chris
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|