Farmall & IHC Tractors Discussion Board |
Re: GN trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by captaink on March 14, 2006 at 09:22:42 from (66.115.214.56):
In Reply to: GN trailer posted by Marv on March 13, 2006 at 20:17:15:
Well, I just hauled two M’s home one with a loader and fluid the other bare with a trailer behind by 94 Powerstroke. I borrowed a 28 ft beaver tail double axle dully trailer and the one tractor barely was hanging on. The whole rig weighed in right at 28,000 pounds and it was a load especially pulling hills! As far as electric brakes, they work ok with a good controller, but I think there are better systems out there. A trailer only 20 ft long is short if it is a beaver tail because you only have about 16 ft of deck. Although I much prefer a gooseneck to a bumper hitch trailer, the GN is a much higher load and center of gravity. Not that this is a problem, just something to keep in mind.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|