Farmall & IHC Tractors Discussion Board |
Re: SNOW DAY!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by The tractor vet on March 13, 2006 at 07:49:42 from (64.179.117.111):
In Reply to: Re: SNOW DAY!!! posted by Kelly C on March 13, 2006 at 07:21:02:
Ahhhh grass hopper you must get all the timing marks on ft. of engine lined up then you must get the slot in oilpump drive to set at 30 degree of bolt hole in dist hold down So one must read book or one will be on here tryen to figure out why one can not get tractor to run or time up , and believe me timming is IMPORTANT ON 6 CYLINDER TRACTOR. So look in the book and you will see what i am talken about, before one get in trouble and find that you have to pull the engine out and pull the ft. cover AGAIN .
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|