Farmall Tractors Discussion Board |
A Transmission Seal Job
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Dave on January 10, 2000 at 09:53:38 from (128.113.2.55):
I'm getting ready to fix the seals on my A's transmission/differential assembly. It leaks on both sides. I feel pretty good about it, but I do have a few questions before I start: 1. Why does it leak when it is standing still? This makes me think the oil level must be above the level of the seals, which means the bearings and seals are submerged in oil all the time. I know the trans holds 5 qts, but is it normal to have the seals below the oil level? On the engine, the crankshaft bearings and seals are above the "full" oil level. Is the trans. different? Can I check the oil level without draining it all out to see I have 5 qts? 2. I hear there are both felt and rubber seals available. I have read that the felt ones are too thin, so that two must be sandwiched together for the proper thickness. It makes sense to me to slide the seal over the end of the differential shaft, and then slide the shaft into the differential to avoid pushing the seal into the case. Does this make sense? Also, Central tractor sells what it calls "Rear Axel Seals" for a 'A,' but I would say they are for the rear axel: down where the wheel goes, and not the differential. Is this the right part? Or should I go to NAPA? What kind of specs. does NAPA need to get me the right seal? I guess shaft diameter, but do they need thickness or other info as well? I see I went on a bit, but thanks for reading through all that. I appreciate any experience/advice you can share.
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|