Farmall & IHC Tractors Discussion Board |
Re: 1066- to IaGary etal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on March 01, 2006 at 05:46:36 from (66.202.111.116):
In Reply to: 1066- to IaGary etal posted by Michael Sheik on March 01, 2006 at 04:58:16:
Pretty much stright foward but you have to reset the snap rings on the on the brake adjustes and also check them for broken springs and the littel pin that holds them together , the piston does not have much movement of the adjusters and the spring is heavy and hard to move read the book on the setting spec. of the snap rings and if not done correctly the brakes will drag. It is also wise to rebuild the brake piston with new O/Rings and put new seals in at this time for the cost it is cheep insurance , cleand up the surfaces that the O/Rings ride on with 180 emery clothe and wash up and blow dry. I use white grease to lube the O/Rings and mating surfaces .
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|