Farmall & IHC Tractors Discussion Board |
Re: Broken Pressure Plate in a 2+2
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JJK on February 11, 2006 at 20:33:17 from (216.189.131.152):
In Reply to: Re: Broken Pressure Plate in a 2+2 posted by the tractor vet on February 11, 2006 at 13:52:14:
I'll bet he impressed himself more than the girls. The MX Magnums have a small drive shaft from the engine to the transmission and they have greaseless u-joints in them. We are seeing problems with this now. Starts out with a bad vibration and if not taken care of right away the cross will break and send the shaft on a violent spree in front of the cab under the air cleaner. In this process when the hyd's stop the tractor comes to an immediate halt and if your going somewhat fast you will kiss the windshield if you don't have the seatbelt on. This did happen to one of our customers and I guess it'll wake you up.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|