Farmall & IHC Tractors Discussion Board |
Re: F12 Cam Bearings
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KevinH on February 10, 2006 at 16:05:22 from (69.59.112.142):
In Reply to: Re: F12 Cam Bearings posted by El Toro on February 10, 2006 at 14:53:54:
The F12 only used the Wauki(listed in the TC9-B parts book as the 'FL') for the first couple years, then went to the IH engine(serial#'s 600-608 and 3035 and up). I have the IH engine and I put 4 sleeve assemblies in it from NAPA that their book listed for the 113 and they matched the ones I took out exactly. I used my original rods and cam. It's been running since '97 so I feel confident the parts matched. And it had cam bearings(the parts book lists them for the IH engine as 31185D or 24515d(front) 31186D or 24420D(center) and 31187D or 24516D(rear). Kevin
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|