Farmall & IHC Tractors Discussion Board |
Re: farmall 706 quits running
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on February 10, 2006 at 07:01:18 from (66.202.111.22):
In Reply to: farmall 706 quits running posted by Troy Schwartz on February 09, 2006 at 19:19:06:
Well i need to know more but here like others have said , do you have good fuel flow to the carb , i have seen floating dabre in the fuel tank clog the stem on the sediment bowl and when it stops running float away till it covers the stem again . Next is a coil that when it gets hot it breaks down and shuts the tractor off till it cools down it could be a bad condenser or it could be that someone has bypassed the resistor and causing a problem at the points and coil . It could be the fuel shutoff selenoid but most of the time when they go back it just won't start. Next if it pings and rattels and knockes then pulls down and stops then you got big problems as she is locking up because you are not running the wright gas and your timming is off and the pistons are swelling up and gulding to the sleeves only use 93 octain gas in them BTDT.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|