Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: 6 or 12 volt?


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by John T on February 05, 2006 at 14:44:28 from (66.244.90.98):

In Reply to: 6 or 12 volt? posted by Mark Co on February 05, 2006 at 13:14:34:

Mark, Im not a fan of the 8 volt system, its an oddball to say the least. If you decide to change, I would go ahead and convert it to a full much more standard 12 volt while youre at it. If it has a genny with a Voltage Regulator, you can simply change to a 12 volt Voltage Regulator to charge a 12 volt battery, thats NOT perfect or the engineering proper way to do it, but it can work even if marginally. The starter will still work at 12 volts, although it can be a lil tough on starter drives. A better way on the genny is to have a genny shop convert the old 6 volt unit to a full fledged 12 volt genny or just buy another 12 volt unit and a 12 volt VR. Of course, you could also change over to a Negative grounded 12 volt alternator system like many do, its your call.

If its a coil ignition instead of a Magneto (NO change needed), it would be cheapest n easy to add an external series voltage dropping (12 to 6) Ballast Resistor after the switch and ahead of the coil, unless you have a full 12 volt rated coil you wanna use. Change any light bulbs to 12 volts, of course.

If you decide NOT to change, to improve cranking performance, I recommend the biggest highest rated battery that can physically fit into the box and the use of 00 Gauge battery n starter n ground cables with a ground cable as close to or on the starter as possible and be sure the starter switch and starter are both in top condition. If the engines not worn out and shes tuned up real good, even 6 volts ought to still start an M in cold weather with the proper oil and good fuel by milking the starter up n over one piston at a time. However, if anything at all is marginal, thats where the 12 volt can still start her where the 6 volt may fail.

The good Bob M has all sorts of wiring diagrams to get you converted also.

Best wishes

John T


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy